BERESKIWAMI 2S LADIESUTILITY

This model was available
only in limited regions.
BERES KIWAMI2 2S LADIES UTILITY

Page Top

TECHNOLOGY

Low center-of-gravity design.

The iron-like neck provides a small-sized clean-cut head form, allowing golfers to easily catch and scoop up a ball and use on any lie with great confidence. Also the center of gravity is set near the impact point for a powerful and stable trajectory.

Page Top

SPEC

Head material/Manufacturing process SUS630 / Casting
Face material/Manufacturing process High-strength custom steel / Rolling
Shaft BERES KIWAMI Ⅱ
Flex L
# (No.) UT
Loft (deg.) 22
Head volume (cm3) 130
Length (inches) 38.75
Lie angle (deg.) 61.0
Distance to Center of Gravity (mm) 31.5
Height to Center of Gravity (mm) 22.0
Depth to Center of Gravity (mm) 26.0
Gravity Angle (deg.) 18.0
Swing weight L B9
Gross weight (g) L 300
Made in Japan
This model was available only in limited regions.

Page Top

SHAFT

Shafts that Dedicated to KIWAMI II

This dedicated shaft was newly developed for KIWAMI at Sakata Factory over a number of years.
This shaft targeted at athletes, was designed to have a rigidity property to achieve stable deflection and transmission of power to a ball without loss. Its higher rigidity at the distal end and the control of the deflection and delay of the head allows player swing this shaft through with reliability. In addition, higher rigidity at hand decreases rigidity changes in the middle portion, resulting in a shaft that deflects entirely, naturally and smoothly.

Material Carbon
Kick-point Low
Butt diameter (mm) 15.3
Tip diameter (mm) 8.6
Flex L
Gross weight (g) L 39.0
Torque (deg.) L 5.75
Frequency (cpm) L 227
Data refers to the 2S grade/shaft only The torque and vibration frequency were measured with no head mounted

Page Top

HONMA SHOPS

Detail

Page Top