BERESKIWAMI2 4S LADIESDRIVER

This model was available
only in limited regions.
BERES KIWAMI2 4S LADIES DRIVER

Page Top

TECHNOLOGY

Crown and Sole

The crown and the sole are made of KS120 titanium superior in a high strength and excellent formability. It has partially thinned by chemical milling to realize a design with more strength, optimal deflection and also total weight reduction. This contribute to provide a perfect deep and low center-of-gravity design.

Face

The Dual Fusion face(twin cup face) optimized for the R & A conforming series. Molded by Ti-6-4 materials forging and achieved high strength, wide area repulsion, and lighter weighted head are all made possible by reducing the thickness of the impact area.

Face pressure

Weight

Internal weights are attached at the deepest and lowest center-of-gravity positions. Three-weight system: By placing weights of 9grams in total to the toe and heel areas near the face, achieves more stable head behavior and a lower center of gravity.

Page Top

SPEC

Head material/Manufacturing process KS120/Forged
Face material/Manufacturing process 6-4 Titanium / forged
Length (inches) 44.25
Shaft BERES KIWAMI Ⅱ
Flex L
Loft (deg.) 11
Head volume (cm3) 460
Lie angle (deg.) 60.0
Distance to Center of Gravity (mm) 36.0
Height to Center of Gravity (mm) 36.5
Depth to Center of Gravity (mm) 36
Gravity Angle (deg.) 20.0
Swing weight L B9
Gross weight (g) L 256
Made in Japan
This model was available only in limited regions.

Page Top

SHAFT

Shafts that Dedicated to KIWAMI II

This dedicated shaft was newly developed for KIWAMI at Sakata Factory over a number of years.
It was designed so that the entire shaft creates a natural deflection and makes the most of the entire deflection when drives a ball. Even a slow swing accelerates the head powerfully for a long carry. Its higher rigidity at the distal end ensures a stable directional property.

Material Carbon
Kick-point Low
Butt diameter (mm) 15.2
Tip diameter (mm) 8.6
Flex L
Gross weight (g) L 38.0
Torque (deg.) L 6.0
Frequency (cpm) L 191
Data refers to the 4S grade/1W shaft only The torque and vibration frequency were measured with no head mounted

Page Top

HONMA SHOPS

Detail

Page Top