BERESKIWAMI2 2S LADIESDRIVER

This model was available
only in limited regions.
BERES KIWAMI2 2S LADIES DRIVER

Page Top

TECHNOLOGY

Crown and Sole

The crown and the sole are made of KS120 titanium superior in a high strength and excellent formability. It has partially thinned by chemical milling to realize a design with more strength, optimal deflection and also total weight reduction. This contribute to provide a perfect deep and low center-of-gravity design.

Face

The Dual fusion face specially optimized for HT-02. Area-specific thickness of forge-casted Ti-6-4 provides a high-strength, lighter weight and a kickback area is expanded in all direction.

Face pressure

Weight

Internal weights are attached at the deepest and lowest center-of-gravity positions. Three-weight system: By placing weights of 9grams in total to the toe and heel areas near the face, achieves more stable head behavior and a lower center of gravity.

Page Top

SPEC

Head material/Manufacturing process KS120/Forged
Face material/Manufacturing process 6-4 Titanium / forged
Length (inches) 44.25
Shaft BERES KIWAMI Ⅱ
Flex L
Loft (deg.) 11
Head volume (cm3) 460
Lie angle (deg.) 60.0
Distance to Center of Gravity (mm) 36.0
Height to Center of Gravity (mm) 37.0
Depth to Center of Gravity (mm) 36.0
Gravity Angle (deg.) 20.0
Swing weight L C0
Gross weight (g) L 263
Made in Japan
This model was available only in limited regions.

Page Top

SHAFT

Shafts that Dedicated to KIWAMI II

This dedicated shaft was newly developed for KIWAMI at Sakata Factory over a number of years.
This shaft targeted at athletes, was designed to have a rigidity property to achieve stable deflection and transmission of power to a ball without loss. Its higher rigidity at the distal end and the control of the deflection and delay of the head allows player swing this shaft through with reliability. In addition, higher rigidity at hand decreases rigidity changes in the middle portion, resulting in a shaft that deflects entirely, naturally and smoothly.

Material Carbon
Kick-point Low
Butt diameter (mm) 15.3
Tip diameter (mm) 8.6
Flex L
Gross weight (g) L 42.0
Torque (deg.) L 6.1
Frequency (cpm) L 193
Data refers to the 2S grade/1W shaft only The torque and vibration frequency were measured with no head mounted

Page Top

HONMA SHOPS

Detail

Page Top